Juniper
JN0-363
Q1:
You are asked to configure filter-based forwarding on a Junos device.
Which two statements are correct in this scenario? (Choose two.)
☐
A
You must create a routing policy.☐
B
You must create a route target.☐
C
You must create and apply a match filter.☐
D
You must create a routing instance.
Juniper
JN0-363
Q2:
Exhibit
Referring to the exhibit, what must be included in the Route1 configuration when establishing an EBGP session with the ISP?
○
A
A local address must be specified.○
B
A local AS must be specified.○
C
The BGP session type internal must be specified.○
D
The BGP session type external must be specified.
Juniper
JN0-363
Q3:
Which two statements ate correct about the BGP next-hop attribute value? (Choose two.)
☐
A
By default, the next-hop value is changed across IBGP links.☐
B
By default, the next-hop value is changed across EBGP links.☐
C
By default, the next-hop value is not changed across IBGP links.☐
D
By default, the next-hop value is not changed across EBGP links.
Juniper
JN0-363
Q4:
How does a Junos device learn about MAC addresses when II is first connected to an Ethernet LAN?
○
A
The device sends out a network broadcast message asking tor all devices and MAC addresses on the network and stores this information In addition lo the interface from which the response was received.○
B
The device learns the destination MAC addresses from traffic in the network and stores this MAC address in addition to the interface from which the traffic was received.○
C
The device learns the source MAC addresses from traffic in the network and stores this MAC address in addition to the interface from which the traffic was received.○
D
The device sends out a network multicast message asking for all devices and MAC addresses on the network and stores this Information in addition to the interface from which the response was received.
Juniper
JN0-363
Q5:
Exhibit
Referring to the exhibit, which two statements are correct? (Choose two.)
☐
A
The OSPF Interfaces are configured as point-to-point.☐
B
The ge-0/0'1.0 Interface is configured as passive.☐
C
The R2 device is an ABR.☐
D
Junos OS default OSPF hello timers and dead intervals are used on all interfaces.